Mede8er Forum > Mede8er Products > MED500X2/MED400X2/MED400X2S/MED450X2 > General Discussion > Problem with activation "Resume scan"
Pages: [1]   Go Down
« previous next »
Print
Author Topic: Problem with activation "Resume scan"  (Read 283 times)
caka
B8a Tester - X2
Active Member
****
Offline Offline

Posts: 66
« on: December 12, 2011, 12:45:50 pm »
The problem is in enabling "Resume scan" option.

I try with all kind of combinations; scaned disk, not scaned disk, stoped process of scaninig.. but no luck with enabling option.

Can someone help? 

Thanks!

config: Med500X2 fw v2.0.2.
           internal HDD WD Green 500GB SATA2 formated in 500x2
           wi-fi connection
Logged
Mede8er1
Administr8or
Hero Member
******
Offline Offline

Posts: 2 741
« Reply #1 on: December 12, 2011, 12:58:50 pm »
caka

Switch the Auto Scan to on and the press the Green button. If you enter the Media Library and then go back to the Home Page it will start to scan


Mede8er1
Logged
Mede8er1
The Greatest Show on Earth
caka
B8a Tester - X2
Active Member
****
Offline Offline

Posts: 66
« Reply #2 on: December 12, 2011, 01:11:39 pm »
Yes I know that, thanks! 

But I would like that mede8er not doing scan at every start.
 
With "Resume scan" I should decide when to scan disk?
Logged
jer1956
Global Moder8or
Hero Member
*****
Offline Offline

Posts: 9 366
« Reply #3 on: December 12, 2011, 01:13:54 pm »
You only need turn on autoscan once....boot with it once....and then you disable it.  You cannot resume something which hasn't been started. It is resume scan....not manual scan.
Logged
Pages: [1]   Go Up
Print
« previous next »
Jump to: