http://www.mede8er.org/beta/Firmware_Final/MED500X2/MED500X2_SECURE_V1.0_23May.rarMede8er1
UnZIP or UnRAR and will find one file named install.img. Copy this file to the root directory of a Flash Drive. Plug the flash drive into the Mede8er.
DO NOT REMOVE POWER DURING THE EMERGENCY RECOVERY PROCEDURE.Setup Menu Update with Auto Configuration Restore Open the Setup Menu and select the “Misc” tab. Now select USB upgrade option. After +- 5 sec the screen will display the current Firmware Version and the New Firmware Version. You will have the option to select “OK” or “Cancel”. Select “OK” and the Mede8er will reboot within +- 1 second and start the update process will start in +- 10 seconds. During the update process the front facia Blue LED will flash and you will see the version of the Firmware and the install progress bar on your TV screen. After the update is complete the Mede8er will reboot with the new firmware installed.
If the Mede8er does not reboot within 5 seconds (after pressing the "Enter" button) then press the "Home" button to initiateEmergency Method (Resets Configuration to Default)Disconnect the power jack at the rear of the Mede8er then plug it back in - Now press the on/off button and hold it pressed for 10 seconds and then release.
After approximately 15 seconds the LED on the Mede8er with flash blue and you will get a progress bar on your TV display (some TV's will not display this) wait until the Mede8er re boots itself +- 60 sec. Your Mede8er is now updated.
