Author Topic: Philips 9400 Pronto Remote xcf file for Mede8er MED500X  (Read 15227 times)

Offline spydey

  • Newbie
  • Posts: 8
  • Helpful Contribution Status: +0/-0
Re: Philips 9400 Pronto Remote xcf file for Mede8er MED500X
« Reply #15 on: July 04, 2011, 12:15:27 pm »
Sounds great,

I am finding that most of the remote control codes work for the MED500X2 remote, but a lot of codes have a different function.

One of the things which I did find was that the codes for left,right,up and down only move a single position on continuous hold. The original remote will scroll down the entries when holding down the button. I am still trying to find the correct code which also makes this possible on the Pronto.

Regards,
Spydey

Offline smi

  • B8a Tester - 1000X3D
  • Newbie
  • ****
  • Posts: 31
  • Helpful Contribution Status: +0/-0
Re: Philips 9400 Pronto Remote xcf file for Mede8er MED500X
« Reply #16 on: November 13, 2012, 03:17:37 pm »
Will these codes work for the 1000X3D too or could you provide an additional xcf file?

I plan to by a 1000X3D soon and have a Pronto 9600.

Thanks
Hartmut
600X3D
HDMI in Yamaha RX-A 3020
HDMI in Beamer Epson TW 4400
wired network to Qnap TS 110
wired network to Qnap TS 212

Offline Mede8er1

  • Administr8or
  • Hero Member
  • ******
  • Posts: 3 766
  • Helpful Contribution Status: +101/-24
Re: Philips 9400 Pronto Remote xcf file for Mede8er MED500X
« Reply #17 on: November 13, 2012, 03:47:58 pm »
smi

Pronto codes for X2 / X3 (codes are the same)

http://www.mede8erforum.com/index.php/topic,7224.msg46046.html#msg46046

Mede8er1

Mede8er1
The Greatest Show on Earth
Read the user Guides
http://www.mede8er.com/mede8er_support_user_guides.htm